No, however the operator will be at a disadvantage without a display,
the only warning information available will be the horn, and the operator
may not be able to identify what caused the warning system to activate. An
overview of the warning system follows:
The SmartCraft warning system incorporates the display screen, the
warning horn and the Guardian Protection system. The warning horn is
located inside the remote control or is part of the ignition key switch
wiring harness.
Alarms Warnings - When a problem is detected, the warning horn
sounds and the name of the offending alarm appears on the display.
- If problem can cause immediate engine damage - the horn will sound
continuously and the Engine Guardian System will respond to the problem
by limiting engine power. Immediately reduce throttle speed to idle and
refer to the warning messages on the monitor and descriptions in the
Operation, Maintenance and Warranty Manual to tell you what to do about
it.
- If problem will not cause immediate engine damage - The horn will
sound but not continuously.
Refer to the warning messages on the monitor and descriptions in the
Operation, Maintenance and Warranty Manual to tell you what to do about
it. Use the Bookshelf link on the Dockstore page if you need to place an
order for a replacement manual.
Engine Guardian System - Monitors the critical sensors on the
engine for any early indications of problems. The system will respond to a
problem by reducing engine power in order to maintain a safe operating
condition. The monitor display screen will show the percent of power
available.